SA International Forum Homepage
Forum Home Forum Home > EnRoute FAMILY > General EnRoute
  New Posts New Posts RSS Feed - Start point
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Start point

 Post Reply Post Reply
Richard Terry View Drop Down

Joined: 18 March 2011
Location: Canada
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote Richard Terry Quote  Post ReplyReply Direct Link To This Post Topic: Start point
    Posted: 14 May 2014 at 4:06pm
Is it possible to designate point for the CNC to start
it's operations from after performing a tool change? It
always seems to start from the bottom left corner, which
doesn't always make sense. Sometimes the only way I can
ensure that the operations are sequenced the way I want
is to manually order them. This is pretty tedious
especially when the shortest toolpath option orders them
perfectly except it starts from the wrong point.

Any tips?


Back to Top
shawrouter View Drop Down

Joined: 18 November 2008
Location: United States
Points: 69
Post Options Post Options   Thanks (0) Thanks(0)   Quote shawrouter Quote  Post ReplyReply Direct Link To This Post Posted: 16 May 2014 at 8:39am
Group your first tool as one and then start from the right and group your second tool in small manageable sections.
Now do a manual order by group. I attached a screen shot. I hope this helps. Good luck.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.03
Copyright ©2001-2015 Web Wiz Ltd.