SA International Forum Homepage
Forum Home Forum Home > EnRoute FAMILY > General EnRoute
  New Posts New Posts RSS Feed - Enroute 4 - Post Processor
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Enroute 4 - Post Processor

 Post Reply Post Reply
Author
Message
adecapuamsi View Drop Down
Apprentice
Apprentice


Joined: 16 July 2014
Location: United States
Points: 1
Post Options Post Options   Thanks (0) Thanks(0)   Quote adecapuamsi Quote  Post ReplyReply Direct Link To This Post Topic: Enroute 4 - Post Processor
    Posted: 16 July 2014 at 9:14am
I have been using my Enroute 4 with a Multicam M Series
machine for years now. However, we just bought an
Anderson Stratos machine that I would like to use the
Enroute for as well.

For the multicam we had a post processor that came with
the machine - Enroute would send the file through that
and then to the machine. I am looking for a post
processor that can do the same with my Anderson Stratos
Machine (with Fanuc oi-mb controller)

Can someone please guide me in the right direction? I am
really at a loss right now.

Thanks.
Back to Top
paloalto_17 View Drop Down
Admin Group
Admin Group


Joined: 29 October 2012
Location: United States
Points: 215
Post Options Post Options   Thanks (0) Thanks(0)   Quote paloalto_17 Quote  Post ReplyReply Direct Link To This Post Posted: 17 July 2014 at 6:30pm
There is a driver in Enroute that would most likely work. It is listed under FanucOI instead of under Anderson.


Best Regards,
Aaron

Edited by paloalto_17
Back to Top
Todd Zuercher View Drop Down
Master
Master


Joined: 16 April 2010
Location: United States
Points: 136
Post Options Post Options   Thanks (0) Thanks(0)   Quote Todd Zuercher Quote  Post ReplyReply Direct Link To This Post Posted: 13 August 2014 at 10:51am
Did you try the Andi1 or Andi2 drivers?  Also look at the drivers for Omnitech. (specifically the Fanuc one) The Omnitech machines are a similar setup, built by Anderson (and are now an Anderson subsidiary). 
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.03
Copyright ©2001-2015 Web Wiz Ltd.