SA International Forum Homepage
Forum Home Forum Home > EnRoute FAMILY > General EnRoute
  New Posts New Posts RSS Feed - Disable "proportional" option?
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Disable "proportional" option?

 Post Reply Post Reply
Author
Message
ABates View Drop Down
Apprentice
Apprentice


Joined: 12 February 2015
Location: United States
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote ABates Quote  Post ReplyReply Direct Link To This Post Topic: Disable "proportional" option?
    Posted: 10 March 2015 at 3:23pm
I use the Precision Input Center often, but I rarely open it and use it to adjust sizing proportionally. Is there a way to disable the "proportional" option which is always checked as a default?
Back to Top
paloalto_17 View Drop Down
Admin Group
Admin Group


Joined: 29 October 2012
Location: United States
Points: 195
Post Options Post Options   Thanks (0) Thanks(0)   Quote paloalto_17 Quote  Post ReplyReply Direct Link To This Post Posted: 12 March 2015 at 1:52pm
When using the Precision Input center you can uncheck
the Proportional box and it should remember that setting
as long as you are working in that document. If you
close Enroute though that option is checked again, and
there is no setting that I know of to change that
default setting.

Best Regards,
Aaron
Back to Top
Stewey View Drop Down
Professional
Professional


Joined: 07 May 2008
Location: Australia
Points: 89
Post Options Post Options   Thanks (0) Thanks(0)   Quote Stewey Quote  Post ReplyReply Direct Link To This Post Posted: 05 April 2015 at 7:47am
I find it a pain too...
moreoften you want to rescale only one dimension - stretching or pushing Z to a set figure, or pulling X or Y to the width of the substrate- without altering the other two dimensions.

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.03
Copyright ©2001-2015 Web Wiz Ltd.