SA International Forum Homepage
Forum Home Forum Home > EnRoute FAMILY > General EnRoute
  New Posts New Posts RSS Feed - 3d Bullnose
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

3d Bullnose

 Post Reply Post Reply
Author
Message
SDesign View Drop Down
Apprentice
Apprentice


Joined: 12 January 2006
Location: USA
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote SDesign Quote  Post ReplyReply Direct Link To This Post Topic: 3d Bullnose
    Posted: 12 January 2006 at 1:23pm

I am trying to make a bullnose letter in Enroute using a 3 dimensional toolpath. I want the edges to have the bullnose and the top surface to stay flat. Should I make the letter a relief and then apply a toolpath to it? If anyone has any suggestions that would be great.

thank you

Back to Top
Hasign View Drop Down
Master
Master

Staff

Joined: 13 July 2004
Location: USA
Points: 180
Post Options Post Options   Thanks (0) Thanks(0)   Quote Hasign Quote  Post ReplyReply Direct Link To This Post Posted: 20 January 2006 at 12:51pm
You could create a bevealed relief and specify a base and LIMIT the height of the beveal. I will email you a sample file.

Hasign
Back to Top
ZSteve View Drop Down
Expert
Expert


Joined: 14 November 2004
Location: USA
Points: 19
Post Options Post Options   Thanks (0) Thanks(0)   Quote ZSteve Quote  Post ReplyReply Direct Link To This Post Posted: 23 January 2006 at 7:51am

use your "limit to hight" feature when you creat your relief IE: 1" round over relief with a 3/4 limit to hight.

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.03
Copyright ©2001-2015 Web Wiz Ltd.