![]() |
3d Bullnose |
Post Reply ![]() |
Author | |
SDesign ![]() Apprentice ![]() Joined: 12 January 2006 Location: USA Points: 3 |
![]() ![]() ![]() ![]() ![]() Posted: 12 January 2006 at 1:23pm |
I am trying to make a bullnose letter in Enroute using a 3 dimensional toolpath. I want the edges to have the bullnose and the top surface to stay flat. Should I make the letter a relief and then apply a toolpath to it? If anyone has any suggestions that would be great. thank you |
|
![]() |
|
Hasign ![]() Master ![]() Staff Joined: 13 July 2004 Location: USA Points: 180 |
![]() ![]() ![]() ![]() ![]() |
You could create a bevealed relief and specify a base and LIMIT the height of the beveal. I will email you a sample file.
Hasign |
|
![]() |
|
ZSteve ![]() Expert ![]() Joined: 14 November 2004 Location: USA Points: 19 |
![]() ![]() ![]() ![]() ![]() |
use your "limit to hight" feature when you creat your relief IE: 1" round over relief with a 3/4 limit to hight. |
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |